NEED HELP? 1-800-832-2966
14
PREPARING THE MACHINE FOR USE
Using this Machine for the First-Time
STOP!
The following section describes the required steps for preparing this machine for the first use. Improper assembly or failure to correctly
perform these steps can damage this machine and/or shorten its life. If you are still unsure about how to perform any of these steps
after reading this section, call 1-800-832-2966 Monday - Friday, 9 AM - 6 PM Central Time for customer service.
Once assembled, if this machine is being used for the first time, the following steps are required to prepare it for operation:
Step 1 - Add Oil
This machine requires engine oil to function. FAILURE TO ADD ENGINE OIL WILL RESULT IN SERIOUS ENGINE DAMAGE! Engine oil is a
major factor affecting engine performance and service life.
When new from the package, this machine contains no oil in the engine crankcase.
Add the correct quantity of oil before operating this machine for the first time. When replenishing/changing oil for subsequent use of this machine,
always ensure that this machine has the correct quantity of oil. A bottle of engine oil is included for your convenience. Always use a high-quality
detergent motor oil with an API rating of SG, SH, SJ or higher.
Model MM212RTT Oil Capacity
17.0 Ounces
Oil Type Recommended
SAE10W-30
To check/add oil:
1.
Confirm that the machine is on a level surface. Set the depth regulator lever so the main frame
of the tiller is level.
2.
Unscrew the oil filler/dipstick cap from the engine and wipe it clean with a clean cloth.
3.
Insert the dipstick back into the engine, but do not screw it in. Remove the dipstick and check
the oil level.
4.
The oil level should be to the upper limit mark, if not add oil.
5.
Using a funnel, add high detergent (automotive) motor oil to fill the engine crankcase to the
correct level. SAE10W-30 oil is recommended for general, all- temperature use.
When the engine
crankcase is full, the oil level should reach nearly all the way up to the top of the lower
threads as illustrated.
Do not overfill.
6.
Replace the oil filler/dipstick cap and clean up any spilled oil. When completing an
oil change, please be sure to properly capture and recycle the old engine oil.
➢
Note: The transmission comes factory filled with the proper type and
amount of gear oil.
Step 2
–
Fueling
Add Unleaded gasoline only with an octane rating of 87 or higher.
DO NOT USE E85, OR FUEL WITH MORE THAN 10%
ETHANOL CONTENT. DOING SO CAN CAUSE ENGINE DAMAGE.
Be sure to avoid overfilling, leave 1 inch of air space in the
top of the tank when fueling to allow for expansion. Maximum Capacity: 3.1 Liters
