MED ASSOCIATES INC.
ENV-421 AMP METER
CHAPTER 2 | INSTRUCTIONS
Connect the +6 VDC adapter to the ENV-421, and then plug the +6 VDC adapter to a standard
wall outlet. Turn on ENV-421.
Figure 2.1 – Connect the ENV-421 to a standard wall putlet and connect alligator clips
Connect the alligator clips on the ENV-421 device to two separate rods on the grid floor. See
figure 2.2
Figure 2.2 – Connect the ENV-421 to your grid floor using the clip leads
Ensure the stimulator you are testing is set to “Dummy Load – out”. Next validate the current by
comparing the current reading on the stimulator with the Peak/Hold reading on the ENV-421.
If there is a deviation on the milliamps being reported between the two devices, please contact
support@med-associates.com for further assistance.
To +6VDC Adapter - See figure 1.2
To alligator clips – See figure 1.3
- 2 -
DOC-314 Rev 1.0 Copyright © 2017
MED Associates, Inc.
Summary of Contents for ENV-421
Page 2: ...ENV 421 AMP METER i ...
