MAINTENANCE
The central unit does not need any maintenance.
The sensors MIC LW, MIC MEC LW and infrared sensors have to be installed inside the vehicle,
protected against the infiltration of liquids and condensate and away from heat sources.
The lens of the infrared sensors must not be knocked.
The sensors can be cleaned using a dry cloth. Do not use solvents or paint thinners.
The sensors MIC LW, MIC MEC LW, SEN INFRA LW, SEN INFRA 360 LW and the TX PAR LW
have an indicator LED to check the efficiency of the internal battery.
When the battery runs low, it can be replaced with the following types of batteries:
-
MIC LW, MIC MEC LW and TX PAR LW
batteries, type
-
SEN INFRA LW and SEN INFRA 360 LW
batteries, type
When replacing the battery, do not touch the circuit or the battery with wet hands.
Do not attempt to charge dead batteries. Do not throw on the fire. Do not swallow.
Dead batteries are to be disposed of in dedicated waste battery containers according to laws
currently in force in the individual countries.
Strictly keep the sensors and the batteries out of children's reach.
3V lithium
CR 2032
3V lithium
CR 123 A
WARNING:
-
The BATTERY HOLDER can only be fitted in the MIC LW and in MIC MEC LW with the
battery CR 2032 actually inserted, otherwise it will be impossible to take it out again.
-
When washing the engine, protect the electronic siren adeguately.
+
CR2032
OK
1
2
3
4
5
3 V
+
+
TX PAR LW
CR
20
32
+
3
V
OK
DO NOT INSERT THE SUPPORT IN THE MIC LW OR
MIC MEC LW WITHOUT THE BATTE
OUT.
RY, AS IT WOULD
BE IMPOSSIBLE TO PULL IT
+
1
2
LED
LED
1
3
3
CR2
03
2
+
3
V
12
The battery
can be
replaced with
the sensor
installed.
CR 2032
BATTERY
CR 2032
BATTERY
Summary of Contents for MED 6000.LW
Page 19: ......
