MED Automotive MED 6000.LW User Manual Download

Page: 4 / 20

To simplify the use of the system, we always suggest the pairing of the electronic key
CHD 400 (allowing the system activation / desactivation without the remote control and
the vehicle start).

SIR 050 SIREN

Ask your MED installer for more.
WARNING

MED 6000.LW.

PIN CARD

USER’S GUIDE

INSTALLATION CERTIFICATE

MED 7000.LW

24 Vdc

KIT 24V

3 Beeps

3 blinks

light blue/white

Instantaneous

5 BEEPS

5 flashings

TX PAR LW

2 / 3

TX PAR LW

CHD 400

The system is completed by the

equipped with the internal

buzzer to help in the use of the system, such as the activation / desactivation, the warning
signalings, the alarm memories, etc.
We offer a complete range of accessories designed specifically to be paired with this alarm
control unit, which prove useful to complete the vehicle's protection system, such as the
following for example: wireless sensors with magnetic contact MIC LW or mechanical contact
MIC MEC LW for protecting doors, windows and storage compartments; infrared sensors SEN
INFRA LW (mounted on sides) or SEN INFRA 360 LW (mounted on internal roof); auxiliary
acoustic indicators and the telephone alarm repeater MED-CALL, the satellite protection
systems controlled by both the Control Centre and also self-sufficiently by the vehicle owner.

These instructions are referred to the system completely installed.
The other opening parts will also be indicated as doors, for example: hatch doors, windows,
storage compartments, bonnet, boot, etc.
The other versions are also indicated as
The installer has to give to the vehicle owner the

, THESE

and the

duly filled out and signed, that is valid as product

warranty (to keep on board).
The central unit has to be installed by skilled personnel.
Some functions may exclude others.
Some depend directly on the equipment of the vehicle and on the accessories installed.
The maximum transmission range of the wireless sensors (roughly 10 meters) is reduced in

Follow the instructions below to replace the battery.
A.E.B. S.p.A. declines all responsibility and suspends the warranty in case of any
inappropriate use of the product, in case of tampering or pairing with inappropriate devices.
Position the control unit and the wireless sensors inside the vehicle, away from heat sources
and protected against the infiltration of liquids or condensate; the wires must lead up to the
control unit from below.
A.E.B. S.p.A. reserves the right to bring any kind of improvements without previous notice.
The

can be installed in

vehicles with the

potential divider

With the ignition key turned on, all the remote controls and the electronic key are ignored.

and

of the LED indicate that the door, bonnet or boot is open if connected to

the

wire configured as

input.

Close the door and re-activate the system the system will activate it self and exclude the
control function on this line, also pointing out the condition when de-activating with 8 beeps of
alarm memory.

With the input configured as DELAYED, if the door is not closed the system ACTIVATES and
then runs an alarm cycle after the set delayed time has elapsed (30 or 50 seconds).
In this case the input remains active all the time.

and

of the LED mean that the system is OUT OF ORDER.

PROGRAM the system to activate it again.

Using the transmitter

you can activate an alarm cycle with the siren, turn signals

and supplementary warning devices in the case of a dangerous situation.
With the ignition key turned off, press the button of the

with the symbol

for

seconds consecutively until the alarm cycle starts. The alarm is interrupted by pressing the
panic button or the de-activation button of the

or using the electronic key