MED Automotive MED 6000.LW User Manual Download

Page: 7 / 20

EMERGENCY DESACTIVATION

USE OF THE EMERGENCY CODE

The system can be desactivated without the remote control using the following procedure
shown on the

too, or using the emergency electronic key

Remove the PIN CARD label: the EMERGENCY CODE is now shown.
Insert the ignition key and turn it one time [+15] ON/OFF to switch the LED ON (red pilot light).
Before the LED is switched OFF, press its button as many times as the first number of the
code; each time the LED switches OFF and 1 Beep to confirm.
Wait until the LED is OFF and ON again.
Repeat the 3-4 steps for each remaining code numbers.

When the system is activated the alarm is given / signalised by the siren, the direction indicators,
the LED and the additional warning horns.
Cycles of about 25 seconds, with cut off by the remote control or the emergency procedure

Connected to the LIGHT BLUE/WHITE wire, which can be configured in two different ways:
-

on the system activation.

seconds on activation, then instantaneous.

The alarm is not repeated if the door is left open.
3 alarm cycles if the door is left open, 1 if it is opened and closed again.
You can set just 1 alarm cycle instead of the 3 standard cycles, with the door open.
The alarm is repeated only if the door is closed and opened again after the current cycle is

terminated.

Unlimited alarm cycles.

Detected via radio by the wireless sensors of series: MIC LW, MIC MEC LW:
-

when the system is activated: opening the door, the windows, storage

compartment, etc.

If, when the system is activated, the door, bonnet, windows, storage compartment, etc. is /
are already open, the sensor does not send the alarm.
To activate the alarm it / they must be closed and opened again.
The alarm cycle is not repeated if the door, the windows, storage compartment, etc. is / are
left open.
The alarm is repeated only if the door is closed and opened again after the current cycle is

terminated.
For the whole time the system is activated, 10 overall alarm cycles at the most are possible

from the wireless sensors of the series: MIC LW, MIC MEC LW.

Detected by the wireless sensors of the series:

There must be a lapse of 2 / 3 minutes between 2 subsequent detections, therefore if you get
out of the vehicle and the system activates immediately, the sensor will only be operational at
the end of the 2 / 3 minutes.
The alarm is only repeated after the set 2 / 3 minutes if there is another intrusion or if the

person in the vehicle makes other movements.
For the whole time the system is activated, 10 overall alarm cycles at the most are possible

among all the wireless sensors: SEN INFRA and MIC LW, MIC MEC LW choked.

PIN CARD

CHD 400

1
2
3

4
5

The usual desactivation signal confirms the operation has been completed successfully.

PRESS THE BUTTON ONLY WHEN THE LED IS ON

OPENING OF DOORS, HATCH DOORS, BONNET OR BOOT

Instantaneous
Delayed

OPENING OF DOORS, HATCH DOORS, WINDOWS AND STORAGE COMPARTMENTS

Instantaneously