Medcursor NK-FM-100-BLK, Manual

3 Operating / 4 Miscellaneous

4

3 Operating

3.1 

Adjusting the 

height

You can adjust the height by pulling out the two brackets in the groove. 

NOTE: The feet of the massager is not adjustable. Be sure that the foot 

massager is disconnected to the main outlet before adjusting the height.

3.2

Operating the

appliance

Place the 

on the floor in 

front of  a comfortable chair and plug it into the main  outlet. Sit

down in a comfortable position.  

3.3

Duration of

massage

treatment

In general, you can allow approximately 10 to 15 minutes operation

for each massage session, one to two times a day. Make sure the

appliance is cooled down completely before using it again!          

E

4 Miscellaneous

4.1 

Cleaning and

maintenance

• Before cleaning the unit, make sure it is switched off and dis-

  connected from the mains. 

• Using a soft, damp cloth only to clean the surface of unit after it is 

  cooled down completely.

• Do not use any strong detergents for cleaning, e.g. scouring cream 

  or other cleansing agents, as they may damage the surface of the 

  unit.

• Store the unit in a cool, dry place. 

• Take care when rolling up the mains lead to avoid damaging it.

This  product  should  not  be  disposed  of  together  with  domestic 

waste. Please hand in all electrical or electronic devices at a muni-

cipal or commercial collection point so that they can be disposed 

of  in  an  environmentally  acceptable  manner.  Consult  your  muni-

cipal authority for information about disposal.                               

R

4.2

Disposal

MEDCURSOR

       Shiatsu Foot Massager

1.

 Press Mode selection button to select massage mode and start 

    foot massage, the indicator will light blue. Carefully put your feet 

    on the foot pads.  

2.

 Press the Mode selection button again to active the heat func-

    tion if you like, the indicator will light red. The red light on the foot 

    area will automatically turn off after about 20 minutes of operation. 

    This is due to the over-heating protection built-in on the device. 

    But it will automatically turn on when the temperature cools down.                                  

3.

 Press the Mode selection button the third time to stop using the 

    unit.                                                                                           

4.

 Unplug the appliance from the wall outlet after usage.