8
Installation – All Lock Bolt Configurations
Installing your Medeco XT Safe Lock
Medeco XT
Safe Lock Installation Guide
1. Locate the mounting plate and the two (2)
provided #8-32x1/4” pan head screws, noting
the orientation of the top and bottom of the
mounting plate (shown in Figure 1).
2. Attach the mounting plate on the outside
of the safe door using the two (2) provided
#8-32x1/4” pan head screws.
3. The mounting plate is now installed.
Tip for Swing Bolt Lock Installation
If you are using a swing bolt lock assembly, complete steps 1-3 in this section and skip to the section
titled
Installation – Swing, Dead & Spring Bolt Lock Configurations
and complete all steps. Steps 1-19 in
the
Installation – Dead Bolt or Spring Bolt Lock Configurations
section are not required.
Information on the pre-drilled holes
This installation guide assumes that your door has a pre-drilled common vault door hole pattern and a 3/8”
minimum diameter spindle hole for mounting both the XT Safe Lock Reader on the front of the door and the
lock assembly on the back.
FIGURE
1
