16
7. Assembling your breast pump
Only use clean and dry parts for assembly. Refer to
chapter 6
for cleaning.
7.1 Selecting the correct breast shield size
Make sure to use the correct breast shield size. It is an essential component of effective
pumping, helping to optimise milk flow.
Refer to figure
¢
6 on the foldout pages.
1.
Select the breast shield size by measuring the diameter of your nipple (
¢
6-01).
2.
Select the breast shield size that is slightly larger than your nipple (
¢
6-02).
21mm and 24mm size shields are included in the pack.
For more information on breast shield sizing and other available sizes, visit
www.medela.com
or see
chapter 13
for ordering information.
7.2 Assembling the collection cups
Only use clean and dry parts for assembly. Refer to chapter 6 for cleaning.
Parts needed:
• Tubing
• Breast shield
• Motor unit
• Yellow membrane
• Outer shell
CAUTION
To prevent contamination of your milk:
• Wash hands thoroughly with soap and water before touching the motor unit, parts of the
collection cups and breasts.
• Dry your hands with a fresh towel or a single-use paper towel.
• Avoid touching the inside of the collection cups components.
To make sure that your breast pump works properly and safely:
• Check collection cups components for wear or damage before use. Replace if necessary.
• Always inspect all parts prior to use for cleanliness. If dirty, clean according to
chapter 6
.
• Only use genuine Medela parts. See
chapter 13
for details.
NOTICE
To prevent damage to the breast pump all components must be completely dry
before use.
