3
Attach the Parts
Attach the Pads
1.Loosen the wing nuts on the drum pads.
2.Attach the drum pads to the pad mounts,
and firmly tighten the wing nuts on the
drum pads.
Wing Nut
Wing Nut 1
Tom 1
Tom 2
Snare
Tom3
Wing Nut 1
Wing Nut 2
Attach the Cymbal Pads
Wing Nut 3
Felt Washer
Wing Nut 4
Cymbal Tilter
1
2
Attach the AFI
Insert the AFI position as shown.
1.Remove the wing nut and felt
washer from the cymbal tilter.
2.Place the cymbal pad, felt
washer, wing nut 3 assembly as
shown, and tighten the wing nut
3 to obtain an appropriate
amount of sway.
3.Adjust the cymbal pad position
with the wing nut 4.
Note:
Put the cymbal on the cymbal
adapter and locate the tap of
the adapter in the slot of
the
cymbal
bottom
.
Hi-Hat
Crash
Ride
AFI
Attach the Drum Module
1.Push the cable into the mount holder slot on
as shown.
2.Connect cable to the DB25 Jack on the back of drum module.
3.Attach the module to the mount holder on the
, and
firmly tighten with the screws.
Center Pipe (1)
Center Pipe (1)
Note:
Adjust the drum module position by moving the mount holders as
needed, and firmly tighten the relevant wing nut.
3
1
2
AFI
0
5
25
75
95
100
aw_DD620_Setup Manual_G01_150923_with kick peda
2015
9
23
11:47:59
