User Manual P9-0139-B
9 of 14
Version 1.0.2-2015
User Manual P9-0139-B
9 of 14
Version 1.0.2-2015
Medema A/S
Introduction to the Ergo2 seat
Lever for rotating the seat
The lever must be pulled back
to rotate the seat. The seat can
then be rotated to each side,
locking at each 45°.
The lever is spring-loaded, and the seat is locked automatically
when the lever is released. This lever is located on the right side as
standard, but can also be positioned on the left side.
When the lever is located on the left side, it must be pushed forward
in order to rotate the seat instead of pulling back.
Out/in adjustment of lever
for rotating the seat
Lift the seat off the vehicle.
Loosen the two Allen screws.
The lever can now be adjusted
out/in to the desired position.
Left positioning of lever for
rotating the seat
Remove the two Allen screws
and pull the lever out.
Move the lever in from the
left side and tighten the Allen
screws.
When installing the lever on
the left side, the lever must be
moved forward to rotate the
seat.
Mount the seat again
To ensure that the seat is fully
in position, release the lever
for rotating the seat, to get the
seat all the way down: