User guide P9-0158-B
40 of 48
Version 1.0.2/2011
Medema Production A/S
Troubleshooting
The following is a list of various problems that, in our
experience, may occur. The list gives possible causes and
remedies.
Problem
Possible causes
Remedy
The Mini Crosser will not
go.
The battery indicator is
not lit.
The joystick has not been
turned on (I/O).
The batteries are
completely fl at.
The control fuse has blown.
The main fuse have blown.
Turn on the joystick (I/O)
and wait 5 sec. before
activating the accelerator.
Charge the batteries.
Change the fuse.
Contact supplier.
The Mini Crosser will
not go, but the battery
indicator is lit.
The Mini Crosser has
been overloaded.
The handbrake is on.
There is a fault in the
electronics.
The batteries are fl at.
The charging plug has not
been removed.
Wait approx. 1 min. before
trying again. The vehicle
must be turned off (see
section on Fuses).
Release the handbrake.
Contact supplier.
Contact supplier.
Remove the charging
plug.
The driving speed is too
low.
The speed selector is on
slow.
The electronics are
overloaded.
There is too little air in the
tyres.
Change to a faster speed.
Stop and wait a few
seconds before starting.
Pump the tyres up to the
right pressure.
The driving distance per
charge is too short.
There is a problem with
the batteries.
Low temperature.
There is a problem with
the charger.
There is too little air in the
tyres.
The charging method is
wrong.
Charge the batteries and
check that the green lamp
on the charger lights up
before driving off.
Contact supplier.
Pump the tyres up to the
right pressure.
Read the section on
Charging in the User Manual.
The charging lamp on
the charger does not light
up when the charger is
connected to the mains
and the Mini Crosser.
No power to the switch.
Fault in cable.
Fault in charger.
Turn the switch on.
Contact supplier.
Read the operating
instructions for the
charger.
Contact supplier.
The “ready” lamp on the
charger does not light up
even though the charger
has been on for 10-12
hours.
There has been a power
cut.
The charger is doing a
top-up charge.
There is a problem with
the batteries.
There is a fault in the
charging plug for the Mini
Crosser M Joy.
Reconnect the charger and
repeat the charging process.
Check again half an hour
later.
Contact supplier.
Push the charging plug all
the way in and repeat the
charging process. Read
the operating instructions
for the charger.
Summary of Contents for Mini Crosser M joy
Page 48: ...medemagroup...
