User guide P9-0152-B
12 of 60
Version 3.0.0/2013
Medema Production A/S
Parameter description
Clock
Set time and date using the up / down with arrows. Moving
to the next digit by pressing the ”next” button. Quit with the
”Enter”
Hazard enabled
(On/Off)
By default hazard (emergency lights) is operable even if the
scooter is switched off and the key is removed.
If you wish the hazard not be activated with the scooter
turned off, you should select ”Off.” here.
Alarm enabled
(On/Off) Extra
With this switch ”On”, the burglar alarm is turned on every
time you turn off the scooter. The small lamp next to the
”Trip meter” will fl ash a few seconds interval.
An activated alarm is turned off by switching the key on the
scooter. If you have no opportunity to get to the scooter
with the key, the alarm will switch off after approx. 20th
seconds. Shake / move the scooter again, the alarm will be
activated again.
Tilt Present (On/Off)
Extra
With this parameter set to ”On”, will turn the tilt icons to red
and blinking, and there will be a whining tone (if enabled) if
you are running on a slope that is steeper than allowed.
P&G fault log
Here are the faults that P & G engine management have
registered. The system can record 8 different types of
faults. Each fault can be recorded up to 30 times.
The newest registered fault is written at the top of the list.
They are shown as follows:
[1502] 2
None
None
None
None
None
None
In this case, the fault 1502 appeared twice. If you press
ENTER on the fault you will get an explanatory text. In this
case, ”Solenoid brake fault”
None means that there have been other fault.
In case of fault on the scooter, it will be a great help if
the fault type can be given to the Mini Crosser or his
representative during troubleshooting.
Temperature sensor, alarm system and tilt alarm are built into
the same box that can be acquired as an option for the Mini
Crosser M
2
Cabin.
