User guide P9-0152-B
51 of 60
Version 3.0.0/2013
Medema Production A/S
Problem
Possible causes
Remedy
The “ready” lamp on the
charger does not light up
even though the charger
has been on for 10-12
hours.
There has been a power
cut.
The charger is doing a
top-up charge.
There is a problem with
the batteries.
There is a fault in the
charging plug for the Mini
Crosser M
2
.
Reconnect the charger
and repeat the charging
process.
Check again half an hour
later.
Contact supplier.
Push the charging plug all
the way in and repeat the
charging process. Read the
operating instructions for
the charger.
The “ready” lamp on the
charger lights up even
when partly discharged
batteries are connected.
The fuse in the charger
has blown.
The switch in the charging
plug is malfunctioning.
Contact supplier.
Contact suppliers - read the
operating instructions for
the charger.
The charger lamp is
showing an error.
The charging plug has not
been inserted or there is a
mains fault.
The battery voltage is too
low for charging to start.
Push the charger plug in or
contact the supplier.
Read the operating
instructions for the charger -
or contact the supplier.
Thermometer symbol is
half-red and fl ashes. The
scooter is running at half
speed.
The motor is overheating
and has reached the limit
of when the fi rst safety
switch responds.
Immediately pull over
at a safe distance from
other traffi c and stop the
Mini Crosser. Wait until
the temperature icon
disappears, ca. 3-5 min.
Turn the Mini Crosser off
and on again to continue at
full speed.
Thermometer symbol is
red and alluminated. The
scooter has stopped.
The motor is overheating
and has reached the limit
for when the security
swithc shuts the motor off
completely.
If the Mini Crosser has
stopped at an inappropriate
place in traffi c, turn on
the emergency lights.
If possible disengage
the scooter and push
it away from traffi c. Let
Mini Crosser cool until
the temperature icon
disappears - approx. 3-5
min. Turn the Mini Crosser
off and on again. Now it
can run normally again.
Mini Crosser can not
remember the time.
Battery on main circuit
board has run out of
power.
Contact service technician.
The heater doesn’t work.
Need paraffi n/diesel.
The fuse has blown
Put on paraffi n og diesel.
Change the fuse.
Read the Webasto user
guide for more information.
The washer doesn’t work.
Washer fl uid i missing.
The fuse has blown.
Put on washer fl uid.
Change the fuse.
The windscreen wiper
doesn’t work.
The fuse has blown.
Change the fuse.
