User guide P9-0152-B
52 of 60
Version 3.0.0/2013
Medema Production A/S
If there is an electronic fault, a number of lamps in the battery
indicator will light up. The following table shows what they
mean.
Lamps
Causes
Remedy
1 lamp
The batteries need charging or
the connection to a battery is
poor.
Check all connections between
the controller and batteries. If
these are fi ne, try charging the
batteries
2 lamps
Poor connection to the motor.
Check the connection between
the motor and controller. Contact
supplier.
3 lamps
Short-circuit between the motor
and a battery connection.
Contact supplier - say how many
lamps are lit.
4 lamps
Not in use
5 lamps
Not in use
6 lamps
The S180/200 is prevented
from driving. Inhibit 2 is active.
This may be due to the battery
charger being connected, the
plug to the thermal switches
being disconnected, a fault
in the thermal switch or the
scooter is overheating.
The Mini Crosser will turn itself
off automatically after it has
been stationary for 10 minutes.
The battery indicator fl ashes
with 6 lamps at a rate of about
3 seconds.
Stop the unit and wait 3-5 minutes
before restarting. Turn the key to
0 and then to 1 to reset the fault.
Contact supplier.
To start M2 again, the key must
be turned to position 0 and back
to I.
7 lamps
Accelerator fault.
Contact supplier.
8 lamps
Controller fault.
Contact supplier.
9 lamps
Poor connection to motor
brake.
Magnetic brake is disengaged.
Check the connections from brake
to controller, or push the brake
lever up.
Check that the vehicle is not
disengaged.
10 lamps
The controller has been
supplied with a high voltage in
excess of 38 V. Usually seen in
the case of a poor connection.
Check all connections from the
batteries to the controller.
Running
lights
Charger is connected. Remove
charger.
Remove charger.
Running
lights from
the center
and out.
The accelerator has been
aktivated during start up.
Turn the key back to 0 and to 1 to
reset the fault.
