Service manual P9-0200-S
29 of 82
Version 2.0.2/2012
Medema Production A/S
Maintenance
MC Concept 1103 is designed so that it requires very little care
and maintenance.
However we recommend an annual inspection, which the
following are checked:
Description
Date
Initials
1
Transaxle - clean, check for leakage. Check
bearings.
2
Tire pressure - should be 2.8 bar
3
Tire condition - check for cracks or abnormal
wear.
4
Cables - check that the insulation on the
cables are intact and that no cables are
trapped, fasten loose cables, check for signs
of heat damage.
5
Power Unit w / joystick - check for moisture -
make function tests.
6
Batteries - check the battery poles and strap.
7
Charger - Make sure that the charger gives the
correct charge voltage / current.
8
Fuses - function test.
9
Moving parts, legrests etc. - Lubricated with
acid free oil.
10
Checking the wheels, central wheel, pivot
wheel, anti-tilt wheel - clean up and check for
play.
11
Check the brakes / disengagement.
12
Screws and washers - check that the screws
are fastened properly, and that screws and
washers are intact.
13
Hoist and tilt (check for breaks on the frame,
hoist and tilt. Check that there are no cracks
or breaks - must not be welded).
14
Frame: check for cracks. If there is cracks,
change frame - must NOT be welded.
15
Switches: check the switch controlling the
speed reduction when the hoist is activated.
16
Accessories: check the accessories, manual
and electronic. Replace any faulty fi nger
screws or handles.
17
Test drive - all functions tested in their extreme
positions. The MC Concept is tested with max.
load.
Summary of Contents for MC Concept 1103
Page 82: ...medemagroup...
