Service manual P9-0270-S
33 of 78
Version 2.0.2/2012
Medema Production A/S
Checking the pivot wheel
Place a piece of wood or similar beneath the chassis to lift the
wheel clear of the ground.
Check the bearings in the
swing mode. If there is a
play, tightened it.
If this is not enoug, then
both bearings have to be
changed.
(Art No. Bearing CR-01118)
Notice the number and the
position of the washers.
Now check the wheels.
If there is any play, the
bearings have to be
changed.
(Art No. Bearing CR-00090)
Unmount any protective cover, and loosen the nut. Note the
number and location of the washers.
When the nut and washers are removed, the wheel can be
gently pulled off the shaft.
Notice any spacers and their location.
Mounting in reverse order. Always use a new security nut.
Note!
All nuts are secured with Loctite 243 (blue)
