Service manual 1533-2003-S
21 of 108
Version 1.0.2/2020
Medema Production A/S
Driving the Mini Crosser X1 HD
Getting in and out
It is important to learn a safe technique for getting in and out of
the Mini Crosser.
In general the following method should be followed:
•
Make sure that the Mini Crosser X1 HD is off (switch turned to 0)
when getting in and out, otherwise the Mini Crosser could start if
the accelerator was touched inadvertently.
• Make sure that the brake is on. (Lever for disengaging motor in
top position.)
• Put the steering column in vertical position.
• If necessary, turn the seat through 45° or 90° and make sure that
it is locked in position (clicked into place).
• If necessary, raise the armrest.
For some users the assistance of an attendant can be recom-
mended. The attendant should:
•
Take care not to injure him/herself when lifting/lowering/supporting
the user.
• Make sure that the Mini Crosser is stable and unable to move.
Turn off the Mini Crosser and check that the brake is on and the
seat has been rotated until it clicks into place at either 45° or 90°.
• Make sure that the seat the user is being moved to is stable.
Turn the Mini Crosser off, return the
steering column to upright position, rotate
the seat and raise the armrest.
IMPORTANT!
The Mini Crosser will turn
itself off automatically after
it has been stationary for 10
minutes even if the key has
been turned to driving po-
sition. The battery indicator
flashes with 6 lamps at a rate
of about 3 seconds.
To restart the vehicle, the key
must be turned to stop po-
sition (0) and then to driving
position (1).
