6
| DMR HD3 User Manual 1.0
APRIL, 2015
2
Setting Up the HD3
System Administration
Use this information when you are ready to install
the HD3 hardware at your site. First, plug in the sup-
plied RJ-45 network cable to your network. Second,
turn on the unit by switching the Power Switch on the
back of the HD3 to the ON position. Third, start the
unit by pressing the front panel Power Button
Initial Login
This section describes the procedure for a first time
Administrator login, and for setting the HD3 access
rights. Administrator rights are required to access or
change any of the settings under the Configure and
Manage sections in the main menu and to change all
features of the HD3.
To log into the HD3, browse to its IP address using
your Internet web browser. The default IP address
is:
192.168.1.253
Once you have navigated to the website, you will be
presented with the a login page. The screen capture
below shows the login fields. For the initial login, use
the Login ID “admin” and the default password of
“MediaPOINTE”. Note that the Login ID and password
are case sensitive. The login page is shown in the
screen capture below.
Access Rights
There are three levels of access rights: admin, author
and user. The Adminstrator can control all of the
functions of the HD3. The author can record, stream
and view content. The user can only view content.
Note that the Login ID and the password are case
sensitive. It is not possible to change any of the login
names. Only the passwords can be changed.
Adminstrator (Username: admin)
The Administrator maintains all rights to the HD3. Ex-
clusive Administrator access allows the configuration of:
the date and time; security; IP settings; command line;
e-mail and managing notifications; logging; AV controls;
AV test; jobs; and software
Author (Username: author)
The Author maintains content creation rights on the
HD3. The Author can access or change any of the
settings under the “Record/Stream” section in the main
menu. No password is required for the “author” login as
a default.
User (Username: user)
The user can watch content. No password is required
for the “user” login as a default.
Configure Security
Changing the Administrator Password
By default, the Administrator Username and Password
are set to “admin” and “MediaPOINTE” respectively.
To change the Administrator password, enter a new Ad-
ministrator password in the New Admin Password
field
(10 characters maximum) reenter the new password in
the confirm password field and click the Update button.
The next time the HD3 is accessed, the new admin
password will take effect.
Be sure to write down the new administrator
password and keep it in a safe place. If you forget
the admin password, the HD3 must be reset back to
the factory defaults to enable administrator access.
