DMR200
User’s Guide
V1.1
20
Network Setup
Use this procedure when you first purchase the
DMR300
and when you are ready to
install the hardware at your site.
How to Assign an IP Address
IP addresses may be assigned to the
DMR300
by two ways: DHCP and Fixed (Static) IP.
If your network is configured for DHCP, the IP address will be provided automatically.
To set a Fixed (Static) IP address, see the procedure below for setting fixed or static IP
addresses.
Fixed (Static) IP Address
1.
Connect the Ethernet cable and power up the
DMR300
.
2.
On your Internet browser, enter the IP address of the
DMR300
.
3.
Login to the
DMR300
using the procedure shown below in the “
Logging In
”
section.
4.
Navigate to the network settings page by selecting “
Config IP
”.
This selection will take you to the Network settings page that lists the
current network settings and also has a section you can use to change these
settings.
5.
In order to change to a Fixed or Static IP address, set the
DHCP Client
button
to
Disabled
.
This will allow you to set a fixed address. Enabling DHCP Client will not
allow any fixed settings to take effect.
6.
Fill in the IP Address, IP Subnet Mask, Default Gateway fields.
7.
Make note of the new Fixed (Static) IP Address for future reference. Without
this you will not be able to access the
DMR300
.
Summary of Contents for DMR300
Page 2: ...DMR200 User s Guide V1 1 2 ...
Page 10: ...DMR200 User s Guide V1 1 10 ...
Page 32: ...DMR200 User s Guide V1 1 32 ...