PENCAM
User’s manual
Discreet Surveillance
MT4054
EN
ON/OFF
Camera
Microphone
USB Port
Card slot
Indicator
Reset button
Introduction
Device is a cutting-edge camera built-in a pen. You can
take pictures, save video files with sound. Files are stored
onto microSD flashcard, you can download them directly
from flashcard or through pen connected by USB cable.
Note! Before first use fully charge the device (takes
about 2 hours).
Charging
Unscrew the pen in half of its length. Use included USB
cable to plug it to USB port in PC computer. During charg-
ing red LED is blinking, when fully charged red LED is on
constantly. After charging unplug USB cable and screw
together both parts.
Installing microSD card
Unscrew the pen in half of its length. Put microSD into card
slot, note that flashcard connection pins should facing
mini USB port. Now screw together both parts.
Using pen
To make notes twist on silver ending of pen, after use twist
off to hide pen inside.
Operating
Power on the device
Press and hold ON/OFF button for about 2 sec, green LED
indicator will be on constantly. Device is now in power on
mode.
Taking pictures
Press shortly ON/OFF button. Every time you press it the
device is saving picture on microSD card.
Recording video
Press and hold ON/OFF button for about 2 sec, green LED
indicator will blink 3 times. Device will record files until
user will stop or there is no space onto microSD card.
During video recording green LED will flash every 2 sec-
onds. Press shortly ON/OFF button to stop recording
– green LED will flash 3 times and will be constantly on
again.
Power off the device
Press and hold ON/OFF button for 3 seconds to power off
the device. LED is off.
Note! If no action is taken within 60 sec from powering
on the device it will automatically power off.
Connecting to PC computer
Data storage mode
When device is in off mode unscrew the pen and connect
it to the PC computer using USB cable included in pack-
age. System will automatically install the device as an USB
mass storage device. You can copy all files from pen to win-
dows desktop. During data transfer green LED indicator is
blinking.
Setting data and time
To set actual date and time you need to edit file “time.txt”
stored onto root folder of device in data storage mode.
Open “time.txt” and use windows notepad to edit. File
contains only one line as below:
2012-05-01 23:59:59
Modify this line to actual date and time and save the file.
Next unplug USB cable and wait until LED indicator goes
off. Now turn on device – new time settings will be ap-
plied.
Reset
If you encounter strange behavior of the device you can
put straighten paper clip into “reset hole” to restart the
device.
Note! If battery is running low device will finish current
recording and power off.
Due to continuous development specification and appear-
ance of product are subject to change without prior notice.
For technical support please visit www.media-tech.eu.
Device is equipped with built-in battery, please remem-
ber to charge it once a week.
