CD-3706/P
Operator’s Guide
Document Revision: 030501.1
CD-3000 Series Operator’s Guide
Document Revision: 100102
Page 26
Copying From A Hard Disk Image
After a hard disk image has been created, it can be used as the copying
master source. If you have not already created a hard disk image, do so
now, as described in the previous section.
Multiple Images Disabled
To make copies from a hard disk image that was previously created with the
Multiple Images
feature “disabled” (i.e. from a single hard disk image), the
steps are as follows:
•
From the main operating screen depicted below:
S E L E C T C O P Y O R C O M P A R E
•
Load as many blank discs as are required into the input bin.
•
Press the “COPY” key on the keypad. The screen will now read:
F R O M H D ?
•
Press the “START/YES” key to begin copying from the hard disk
image, to the blank discs in the recorders. Depending on the format type
of the image, something similar to the following will be displayed on the
screen:
E N T E R Q U A N T I T Y :
•
Enter the quantity of discs you wish to copy up to 100:
C O P Y I N G . . . .
G O O D : 0 B A D : 0 O F : 0
Progress will be displayed on the screen during the operation:
C O P Y O K ,
P R E S S S T A R T
G O O D : 0 B A D : 0 O F : 0
•
Press the “START/YES” key, and you will be returned to the main
operating screen:
S E L E C T C O P Y O R C O M P A R E
