CD-3706/P
Operator’s Guide
Document Revision: 030501.1
DVD-QuadraPRO LX Operator’s Guide
Document Revision: 070102
Page 18
V E R I F Y A F T E R C O P Y = O F F
S Y S T E M S O P T I O N S
This displays the
Verify After
status of the QuadraPRO. The Verify
After function will verify a copied disc against the master that it was
burned from immediately after being copied.
M U L T I P L E I M A G E S = O F F
S Y S T E M O P T I O N S
This displays the
Multiple Images
status of the QuadraPRO.
I N S T A L L E D M E M O R Y : 1 0 2 2 M B
S Y S T E M O P T I O N S
This displays the
Installed Memory
of the QuadraPRO.
T O T A L G O O D : B A D :
S Y S T E M O P T I O N S
This displays the number of good and bad copies for the current job.
S E L E C T C O P Y O R C O M P A R E
Press the “2” key on the keypad. You will see several
functions scroll across the screen. Select a function by pressing the
corresponding number on the keypad. Enable or disable the function by
pressing the “Start/Yes” or “Stop/No” key.
0 = V E R I F Y A F T E R C O P Y
S E L E C T O P T I O N
The factory setting for this function is disabled. When enabled, the
Verify After
feature automatically compares discs to the master disc or
hard disk image after copying is completed. Due to the nature of the
various compact disc formats, only CD-ROM Mode 1, CD-ROM Mode
2, CD-ROM XA Mode 2 Form 1, and audio (CD-DA) discs can be
compared.
1 = M U L T I P L E I M A G E S
S E L E C T O P T I O N
The factory setting for this function is disabled. When enabled, the
Multiple Images
feature allows up to four images to be stored on the
hard disk drive at one time. This setting will remain in effect until
disabled, even after restarting the QuadraPRO.
