20
21
INSERTING THE BATTERIES
Requires 2 x AA 1.5 V batteries (included).
1. Open the battery compartment on the back of the control panel (Fig. 1).
2. Note the diagram inside the compartment that shows the correct polarity for battery installation (Fig.
2).
3. Insert the 2 x AA 1.5V batteries (included) with the correct polarity (Fig. 3).
4. Close the battery compartment again (Fig. 4).
CONTROL PANEL BUTTONS (FIG. 5):
[RESET] deletes data from the selected mode.
• To reset all stored information from the previous workout, press and hold the button for 3 seconds.
• Does not erase the total training kilometres (ODO).
[MODE] selects the mode.
• To reset all stored information from the previous workout, press and hold the button for 3 seconds.
• Does not erase the total training kilometres (ODO).
[SET] programs new settings for the selected mode.
• To increase the setting faster, press and hold for 3 seconds. Release and press the button again to
program.
DISPLAY (FIG. 5):
The display turns off after 4 minutes when not in use.
TIME, DIST, CAL and PULSE: Standard setting until reset ([RESET]) or programmed with a new setting
([SET]).
SCAN: Goes through all of the functions below. Press [MODE] to select one.
TIME: Press [RESET] to start the workout or [SET] to program a countdown timer. When the countdown
reaches 0, an alarm will sound. Press any key to mute this.
SPEED: Displays the estimated speed in km/h (kilometres per hour).
DIST: Press [RESET] to display the distance in kilometres for the current workout, or [SET] to program a
countdown from the distance target. When the countdown reaches 0, an alarm will sound. Press any key to
mute this.
CAL: Press [RESET] to display the estimated calories burned or [SET] to program a countdown from the
calorie goal. When the countdown reaches 0, an alarm will sound. Press any key to mute this.
ODO: Shows the total training kilometres of all training.
PULSE: Press [RESET] to display the heart rate or [SET] to program a target heart rate. You must hold
the heart rate monitor handles on the handlebars to allow the heart rate to be displayed. An alarm sounds
when the target heart rate is exceeded. To mute, take your hands off the handles of the heart rate monitor
or press [RESET].
WARNING! The heart rate monitoring system may not work as intended. Over-exercising can result in
serious injury or death. If you notice an unusually strong decrease in your performance, cease training
immediately.
ADJUSTING THE TILT ANGLE (FIG. 6)
Turn the round knob on the main frame to the left to loosen (but not completely remove) the screw. Place
one foot on the rear stand of the Slim Cycle and raise the Slim Cycle while pulling the knob to adjust the
angle (Fig. 7).
M23719_SlimCycle_Manual_A5_20200617_CP.indd 20
M23719_SlimCycle_Manual_A5_20200617_CP.indd 20
17.06.20 16:30
17.06.20 16:30
