2
part no. 200-2410 v3
779QSG_v2
Installation
When locating the Encoder, ensure that a clearance
distance of 25mm (1”) is maintained around the
ventilation grills to allow free ventilation airflow. Items
that could accidentally block the ventilation grills or
impede the cooling airflow must not be located near
the unit.
the Encoder must not be installed where there is a
possibility of exposure to condensation, dripping or
splashing liquids. Containers filled with fluid should
not be located in the vicinity of this unit.
Connect the Encoder unit to the source device using
the appropriate video and audio interface cables. a
Composite video source should be input into the GrEEn
phono connector on the rear of the unit, and S-Video
should be input into the GrEEn (Y) and BLUE (C) phono
connectors (with a suitable adapter). If HDMI audio is
not being used, connect the analogue audio source to
the 3.5mm jack socket audio input using the phono
adapter cable supplied.
the Encoder must be installed using a mains (aC supply)
plug and socket that is located near the equipment,
that remains operable and be easily accessible to
disconnect the unit in the case of an emergency.
Insert the IEC end of the mains cable into the socket
on the rear panel of the Encoder and insert the mains
plug into the wall socket. the BLUE power indicator
LED on the front of the Encoder should illuminate. the
LCD panel will show the boot up progress of the unit.
Until the unit is fully booted, only selected setup items
are available to view on the LCD.
Booting Up
During boot-up, the status LED on the front of the
encoder will flash orange. the LCD will show the boot-
up progress. When booting is complete the status
indicator LED will change colour to GrEEn or flashing
GrEEn to indicate whether the selected video input
source signal is present or not. the LCD will then reflect
the operational status of the encoder.
after boot-up, if the status LED changes to a constant
rED colour, an internal error has occurred in the
encoder, and it should be returned to Cabletime or
your reseller for service. If the status LED is flashing
rED, then a software upgrade is in progress, and it is
important that the Encoder remains powered with a
valid network connection until the unit reboots and
resumes normal operation.
Quick Start Guide
Medias
tar E
volution
