Warning!
Do not wet the device or put it into water or other liquids. For cleaning, use a clean,
dry cloth only.
After each use, remove and detach all the nebulizer components and separately
flush each part (except connection tube) of the nebulizer under running water.
Water temperature must not exceed 50 °C
. Allow all nebulizer parts to air-dry
thoroughly.
Do not clean the connection tube (air tube). If the water droplets accidentally enter
the air tube, and the natural wind can not dry the air tube, then only air tube must
be connected to the nebulizer, and the nebulizer must be switched on to discharge
the water droplets from the air tube. When no droplets are left in the air tube, the
nebulizer cup and mask can be attached on the tube, and the user can start using
the nebulizer.
Warning!
Cold disinfect all parts that come in contact with the patient using denatured
alcohol. Carefully dry all components and the device before reassembling. Store in
a cool, dry place, away from light and heat.
Warning!
Never use benzene, thinners or other inflammable chemical substances for
cleaning.
For increased hygienic safety, never use the same accessories on more than one
patient. Contact local Mediblink representative to order nebulizer spare parts.
Cleaning and maintenance of the compressor nebulizer
Cleaning and maintenance of the nebuliser cup and accessories
Cleaning and maintenance
EN
13
