MODEL 28 FITTING INSTRUCTIONS
1.
Place the PVC backing of the harness against the front of the seat back.
2.
Pass the two top vertical fixing straps up and over the seat back.
3.
Pass the tail-ends of the vertical fixing down through the gap between the seat back and seat cushion and bring them
up to connect through the Aluminium Bar Buckles of the top fixing straps.
Model 28 harness has passed dynamic Impact testing to ISO Draft Standard
10542 Pulse and compiles with the VSE 87/1 voluntary code of practice.
IMPORTANT:
BELTS AND HARNESSES SHOULD BE REPLACED IF THEY SHOW ANY SIGN OF FRAYING OR CUTS,
AND ESPECIALLY IF THEY HAVE BEEN INVOLVED IN AN ACCIDENT.
4.
Position the body harness so that the waist belt will be in line with the waist.
5.
Tighten the vertical straps to fit the seat back as securely as possible and pass the loose ends through the
Sliplok slide.
6.
With the harness unfastened at the waist belt sit the passenger on the understrap which is lying on the seat cushion
and bring their arms through the shoulder straps.
7.
Now bring the understrap up between the legs and loop it back onto the waistbelt over the buckle.
8.
Connect the waistbelt buckle to fasten the harness.
9.
Adjust all straps to fit tightly yet comfortably by pulling the tail-ends of strapping through the adjuster buckles.
10. To remove the passenger from the harness - Unfasten the buckle on the waistbelt at the centre-front.
Aluminium Bar Buckle
Sliplok slide
40mm Adjuster Buckle
(28A & 28ASB only)
Squeeze Adjuster to release webbing
Standard Buckle
Steel Buckle
