12
3.5. Common Interface (CI)
If you want to watch subscription channels, you must first register with the relevant
provider. You will receive a Conditional Access Module (CAM module) and a special
card from your provider after registration. You will find information about the set-
tings in the documentation supplied with the module.
Install the CI components on your television in the following way:
First insert the CAM module in the slot on the side of the LCD TV. Then insert the
card.
Connect the television to the power supply, switch it on, and wait for a moment
until the card is recognised.
Please note that you can only insert or remove the CI module when the
device is in STANDBY mode, or has been disconnected from the mains
power.
The CAM module must be inserted correctly: it cannot be inserted if it is
the wrong way round. The CAM module or the television could be dam-
aged if you attempt to insert the CAM module by force.
3.6. Connecting the power supply
Connect the mains plug on the device to an easily accessible 220 - 240 V ~ 50 Hz
mains socket.
3.7. Switching the LCD TV on and off
The device will be in standby mode as soon as you have connected the mains
plug to the mains socket.
To switch on the device, press one of these
− on the remote control: The Standby/On button .
− On the device: The
button.
Use the Standby/On button
on the remote control to switch the device back
into standby mode. The device will be switched off, but will continue to use
power.
If the device is not receiving an input signal, it will automatically switch
to standby mode after five minutes. A countdown timer will be dis-
played on the screen until this time. This function is not available for all
sources.
31710-2 ML eCom 30031149_221_223 QSG Final.indb 12
31710-2 ML eCom 30031149_221_223 QSG Final.indb 12
04.03.2021 09:58:09
04.03.2021 09:58:09
