50
Press a source key for the device for which you want to control the volume and mute functions. The light of
blue LED will remain lit.
Press the
Mute
key
; the blue LED will go out. If you accidentally selected a device that does not have its
own volume control, the blue LED will flash for 3 seconds.
Programming the volume/mute universal functions to a particular device
You can program the universal remote control in such a way that it will use only that particular device’s own
volume and mute functions. The universal function for this mode or device type is therefore switched off.
Keep the
CODE
key pressed down for approx. 3 seconds until the blue LED briefly flashes and then remains
on.
Press the
Mute
key
until the blue LED light goes out.
Press the source key for the device that is only to have its own volume and mute functions.
Press a volume key. The light of the blue LED remains lit.
Press the
Mute
key
again, and the blue LED light will go out.
Restoring the universal volume/mute functions
If you have changed the universal volume and mute functions, as described in the previous two sections, you
can reset the functions back to the factory settings and thus restore the “Punch Through” effect.
Keep the
CODE
key pressed down for approx. 3 seconds until the blue LED briefly flashes and then remains
on.
Press the
Mute
key
until the blue LED light goes out.
Press the
Mute
key
again. The blue LED light will extinguish completely. The volume and mute functions
are now restored to their factory defaults.
