S
S
A
A
F
F
E
E
T
T
Y
Y
A
A
N
N
D
D
S
S
E
E
R
R
V
V
I
I
C
C
E
E
3
C
ONNECTING
P
OWER SUPPLY
•
Do not open the power adapter housing. When the
housing is open there is a
danger
of severe elec-
tric shock. It contains no user-serviceable parts.
•
The power socket must be in the vicinity of the scanner and
within reach of the power adapter cables.
DO NOT
stretch the
power cables tightly to reach a power socket.
•
To disconnect your scanner from the power source remove the
power cord from the power socket.
•
To avoid power consumption when the device is switched off
either pull out the power plug when the device is not used or
connect the device to a master-/slave power bar.
•
Only use the power adaptor provided with this flat bed scanner
(
HDAD15W101-124
) operating at
AC 200-240V~/50 Hz.
•
If using an extension cord, make certain that it meets your lo-
cal safety
requirements. If in doubt, consult a qualified electrician.
•
To provide additional protection against electric shock, power
surges, lightning strikes, or other electrical damage to your scan-
ner, we recommend the use of a
surge protector
.
Observe the following instructions to connect your flat bed scan-
ner properly:
•
Route the cable so that no one can step on it or
stumble
over it.
•
To avoid damage to the cable
do not place any objects or
furniture on the cable
.
•
Please
unlock
the scanner before use. When you intend
to transport the scanner lock it again (see page 9).
