4
INFO: BEFORE USING
Setting Remote Controller Batteries
When the device is connected to TV/projector, using the remote controller for operating is
recommended.
1. Turn the remote controller over and remove the battery cap.
2. Insert the two AAA batteries into the battery socket.
3. Recover the battery cap, and the remote controller can work now.
Charging Li Battery Set
The device can use the Li battery set for portable using. The Li battery set must be charged
before using it.
1. Connect the battery set with the device.
2. Connect the DC power adaper from the device to the
wall outlet (100V-240V).
3. The LED indicator on the Li battery set will stay on
during the charge process and will not trun off until
the charging finishes.
4. While charging, the device can still work as usual.
Removing Li Battery Set
The device also can work only with connected DC power adapter instead of the battery set. To
remove the Li battery set, please refer to following
instructions.
1. Turn the device over.
2. Push the ejector of the Li battery set to BATTERY
UNLOCK and pull the Li battery set to take it off.
Setting NTSC/PAL System
The device can apply to two TV systems: NTSC and
PAL. Turn the device aside and adjust the NTSC/
PAL switch for fitting your TV system. You can use a
needle or a pen as a tool.
Powering On/Off the Device
The device can be powered on/off by the power switch or the
Power On button on the remote controller.
When the power switch is on, you can use the remote controller to turn
device off and on again.
VIDEO
S-VIDEO
AUDIO
DC / IN
DC / IN
VIDEO
