2
BS 444
CONNECT
Instruction Manual
GB
Target Scale
Not Connected
B) Setting the personal data in the scales
The scales can store the data (gender, athlete mode, height, age) for 8 people with up to 30 memory locations each.
The values preset in the scales are: Male, 165 cm, 30 years old, kg.
Press your foot on the middle of the surface of the scales.
1
Press the SET button until the
memory slot flashes in the
display.
2
Select the desired memory slot
using the
▲
/
▼
-buttons.
3
Press the SET button to save the
selection. Continue accordingly
to make the settings for gender,
athletic condition, height and
age.
4
After you have set your personal
data, the display shows “0.0”.
5
To finish the scale settings,
simply stand
barefoot
on the
scales.
6
The display shows the following
measurements:
• Weight
• Proportion body fat
• Proportion body water
• Proportion muscle mass
• Bone mass
• BMR (calory requirement)
• BMI
2
2
3
A) Simple weight measurements with the „Step-On“ function
1
Simply stand on the scales
bare-
foot
(without socks or similar).
2
Your weight is shown.
Prerequisites for correct measuring results
Reliable measurements can only be achieved under certain prerequisites:
• Always weigh yourself under the same conditions.
• Always weigh yourself at the same time of day.
• Stand up straight and stand still.
• Weigh yourself preferably in the morning, after showering or bathing, and with dry feet.
It is possible to obtain a reliable indication of body weight development from the results if
measurements are carried out consistently.
Automatic user recognition
Automatic user recognition based on last measurement:
Stand on the scales barefoot. Your user data (memory location) is selected automatically.
• If your user data is not selected correctly , select the number
(P1 to P8) by pressing "
▲
" or "
▼
" and confirm with "SET".
Error messages
P1P2 or other combinations of memory locations = The scale recognizes users already saved
based on their weight. In this case, two users have a similar weight. To select the correct user press
the UP key for the left value (example “P1”) and the DOWN key for the right value (example “P2”).
