TREADMILLS MOD. 870A/870S/870C
Rev.1/01.07.2019
© Medisoft RAM Italia S.r.l.. All rights reserved.
17
Precautions when equipment is not in use
When the equipment is left unused for long periods of time, the following steps
should be followed:
•
Turn off the equipment, cut off the electricity by pulling the plug from the mains,
wind the cable, and lay it on the treadmill belt.
•
disconnect any other device (e.g. a PC connected via a serial port).
•
clean the equipment following the instructions specified in paragraph 5.2.1.2.
Dry or let the equipment dry before covering it.
•
Carefully cover the equipment with adequate means, so as to avoid dust,
moisture or the infiltration of other atmospheric agents that might be present in
the environment where equipment will be stored. The environment should meet
specifications as indicated in paragraph 2.3.
•
protect the cables from dust, moisture, sunlight and from heat sources by
storing them in adequate containers or in a cabinet.
WARNING!
Before covering the equipment make sure that the equipment is dry.
Before reusing the treadmill
•
Verify that the equipment and all accessories are in perfect conditions, state of
preservation and cleanliness. If all is verified to be in excellent state, act
accordingly.
•
Start the equipment by switching the power on, and let it work for about an
hour. This procedure allows the equipment to reach operating temperature,
favouring the elimination of any moisture that might have formed inside the
equipment.
•
During this period, it is possible to verify that the equipment functions properly.
2.4
DELIVERY AND CLAIMS
Do not unpack the equipment immediately.
Verify that the number of cartons received equals the number listed on the
delivery note. Verify that the packaging is original, and the treadmill is on its
original wooden pallet. Inspect the packaging for external damage.
It is important to itemise any discrepancies on the waybill and have it signed by
the carrier's agent. Failure to adequately describe external evidence of loss or
damage may result in the carrier refusing to honour
your claim.
If damage is discovered after the wayb
ill is signed, contact the carrier’s agent
immediately by telephone, and in writing. Request an inspection, and a copy of
the inspection report.
If damage is discovered do not discard the packaging materials until all checks
have been
made by the Medisoft RAM Italia representative. Upon being
notified that you have received the equipment, a qualified Medisoft RAM Italia
representative will visit your premises. They will unpack your equipment, check
for internal damage or missing items, and then assemble it according to the
directions of our Technical Service department.
