10
Setting and adjustment
In this chapter you will learn how you can optimally prepare and implement
the session for an auditory system comparison.
Prepare the adjustment as follows:
Prepare the adjustment as follows::
Before the customer arrives ...
1. Start the AUDECOM on the computer. If this is not installed on your com-
puter, follow the steps in the chapter Installing Software.
2. On the start screen, click on the manufacturer logo. You can use its au-
ditory systems for the next comparative adjustment.
3. Switch on the AUDECOM.
To do this, turn the switch on the left (headphone side) to the left.
The operating LED’s are illuminated in blue to display the status.
The computer will attempt to establish a connection to the AUDE-
COM. If it was possible to establish a connection, the connection
LED is illuminated in green.
The loudspeakers automatically increase the volume to the maxi-
mum to always offer a consistent initial output volume. This process
takes approximately 10 seconds so that a volume change is completely
normal during this time.
Tip:
In order to save power, you can switch off the loudspeakers if you will
not use them for the foreseeable future. Do not forget to turn off the lou-
dspeaker when you conclude a session with the AUDECOM. In order to
test whether the loudspeakers are connected, please note the following
located on the back:
Setting and adjustment
LED colour Ready for use
Charge
blue
x
blue-red
x
x
red
x
black
(LED off)
