HUSH endura
™
SPRINTER
3
Prepare the Hush Optimiser
™
Spray Gun cont’d
1. Follow the diagram to prepare the Hush Optimiser™ Spray Gun
a. Unscrew the plastic cup from the Hush Optimiser™ Spray Gun. Pour tanning solution into the cup. Do not fill more
than ¾ full.
b. Carefully screw the cup back onto the main body of the Hush Optimiser™ Spray Gun. Screw the cup on firmly but
DO NOT over tighten. Over tightening will cause the cup to “pop” and damage the threads. Leakage can
then occur requiring replacement of the cup.
c. Locate the air cap (#1) on the Hush Optimiser™ diagram. With the gun facing towards you, slightly turn the air cap
ring (
#1-1, page 6)
anti clockwise to loosen the air cap. Notice that you can now rotate the air cap freely.
d. Look at Mist Applicator Patterns diagram above. Note the position of the air cap and the direction of the spray
pattern. Pattern 1 is for spraying across from side to side. Pattern 2 is for spraying up and down. Patterns 1 and 2 are
the most common positions for applying tanning solutions.
5
2
Set up and operate your PRINCESS
Tanning System:
1. Plug the PRINCESS
tanning system unit into a proper electrical outlet. Make sure that the electric current
you are connecting to is the same as your unit. (110v or 220v). DO NOT attempt to connect the unit to the wrong
electric current as this will not only damage your unit but also void your warranty.
2. Next, locate the male end of the air hose and connect it to the female quick connect on the PRINCESS
tanning system.
a. To insert the coupler pull back on the ring of the black coupler located on the PRINCESS
tanning
system and connect it to the male connector on the hose. Figure 6.
Fig. 6
b. Release the ring to allow the coupler to snap into place. The hose should now be connected to the
unit Figure 7.
Fig. 7
c. To remove the air hose, pull back on the ring of the black coupler and remove
If you have just finished spraying, the connector may be hot. Allow the PRINCESS unit to cool down
or about 10 minutes before disconnecting the air hose from the turbo unit. Use Caution!
7
