HUSH endura
™
SPRINTER
3. Prepare the Hush Optimiser
™
Spray Gun cont’d
e. Turn the air cap (#1) to the position you want. Again with the gun facing towards you, turn the air cap ring (
#1-1, page
6)
clockwise to lock the air cap in place.
f. The spray pattern can be changed from flat to circle using the Pattern Adjusting knob (#12). A circle pattern (as seen
below) can be used for contouring.
2. Next, position the Hush Sprinter™ unit as far away as practical and possible from the area where you will be spraying.
3. Attach the remaining end of the hose to the Hush Optimiser™ Spray Gun as follows:
a. Locate the male connection at the bottom of the Hush Optimiser™ Spray Gun. See figure 8.
b. Pull back on the coupler of the brass connector on the air hose.
Fig 8
←
Flow Solution Screw
←
Pattern Adjusting Knob
How to mist in a spot or circle
8