27. Press Up to change hour and Down to change minutes.
28. Press Set to confirm on the end time. After 3 seconds, the
display Setting Accepted will be shown.
29. Press any key to acknowledge the change.
30. Press Power to go back to the previous menu.
Edit Value
12:00:00
Setting Accepted
Press any key…
20
Program 2 and/or 3
(iii) Changing the ozone (O3) threshold cut-off (if applicable)
31. Repeat steps 17 - 31 for Program 2 and/or 3 (if necessary).
NOTE - If Program 24h is enabled, Program 24h will be priority, followed by Program 1, Program 2 and
Program 3
NOTE - This is to set the cut-off limit of Active Oxygen production into the surrounding air. Once it
reaches the limit, the ozone sensor will automatically stop the device from operating. The device starts
operating again when the Active Oxygen is below the cut-off limit. Only change the O3 Threshold
setting under direct supervision from Medklinn.
