MDS86825DLX3/4 (GPI171)
Revised (A): 11/26/12
Front Wheel Assembly
1.
When inserting the front wheel, make sure the ”FRONT“ sticker is pointed toward
the front and away from the rolling walker
(see Figure A)
.
2.
Insert the wheel to the desired height depicted by numbered holes on the wheel
frame (set to the same number as rear wheels)
(see Figure B)
.
3.
Place a triangular hand screw into the hole. Make sure the triangular hand screw
stays outside of the rolling walker frame
(see Figure B)
.
4.
Tighten the triangular screw
(Important: Hand Tighten Only!)
until secure
(see Figure C)
.
5.
Repeat steps 1-4 for the other front wheel.
Figure A
Figure B
Figure C
8
