www.medoraco.com | 866 - 437 - 8076 | info@medoraco.com
10267_20181113
SCADA outputs offering machine operation
parameters reside within the digital controller.
Please contact Medora Corporation if you are
interested in receiving these parameters.
Motor Controller
- The motor controller is located
near the motor just below the top plate of the
SolarBee. The motor controller is sealed in line
with the electrical cord that runs to the brushless
motor.
The motor controller on the SolarBee receives
power and signals from the main control center
located inside the external enlosure. These
signals are used to operate the brushless motor
at the commanded speed. The motor controller
also sends feedback signals back up to the main
control center.
Due to the high frequency of communication
between the motor controller and brushless motor,
the two components need to be located close
to one another. This is the primary reason for
having the motor controller located directly on the
SolarBee.
All electronic connections on the SolarBee
equipment should only be used for the inputs or
outputs that they are labeled and designed for. If
any of the leads going into the electronic controller
are disconnected, be sure when re-connecting to
place them in the proper position.
Wiring -
All electric wiring includes corrosion-
resistant, industrial cords with molded, weather
and watertight connectors. The connectors
are indexed to prevent improper wiring. A
general electrical schematic can be found in the
Maintenance and Field Adjustment section.
Motor Control Cord
Durable Wiring And Connectors
Features
Features
SB5000
O&M_SB5000_20181113 - 8
