medpack dr. Frei GM-10, User Manual

5

HOW TO ASSEMBLE MANUAL BREAST PUMP

1. Please insert the stem (4) into the silicone diaphragm (3).

2. Insert the silicone diaphragm (3) into the funnel unit (2) as shown. Ensure these two 

parts are filled together.

3. Insert the silicone breast shield (1) by aligning the contours of shield to that of the funnel 

unit (2).

4. Slide the stem (4) into the fork of handle (6), and then assemble the handle on the pivot 

of funnel unit (2).

5. Assemble the dustproof cover (5) to be locked on the funnel unit (2).

6. Align the cover (7) over the funnel.

7. Push the valve membrane (8) into the pump unit (2).

8. Screw the bottle (9) onto the assembled funnel unit (2).

9. Place the assembled bottle (9) onto the bottle stand (10).

* Ensure parts are assembled correctly.

HOW TO USE:

1. Clean all the parts of breast pump, using the steam sterilizer, wash your hand and 

assemble all the parts properly, tightened to avoid leakage.

2. Before start sucking milk, gently massage the breast or use a warm towel to compress 

the breast, which is helpful for extracting breast milk.

3. Sit on a chair relaxed, and tilt your body forward slightly. 

4. Press the breast shield gently and tightly against your breast to create a proper seal.

5. Press the handle gently and feel the suction. You can easily control the suction via the 

fingertip action on the handle.

6. Press the handle for 2 or 3 seconds at a time to imitate the babies natural sucking 

motion. 

7. Sucking two breasts alternately, no more than 10 minutes each time. 

Please Note: 

If you can not draw any milk from the breast after five minutes of operation, 

discontinue use and try again later.