18
19
TIP
You’ll only need to connect your recharger to your
Recharger app at your initial (or first) charging session.
CONNECT YOUR RECHARGER
CONNECT YOUR RECHARGER
Every time you use your programmer, you’ll connect it with your
neurostimulator as instructed on page 2.
The first time you recharge your therapy, you’ll connect your recharger
to the Recharger app. Charging will not occur if the recharger and the
Recharger app have not been connected.
Open your Recharger app on your programmer. If the “Connect”
screen appears, follow the steps below. If not, your device is already
connected and you are ready to recharge your therapy (see page 20).
To connect the app to your recharger:
Turn on or unlock the smart programmer.
Tap the
recharger
icon.
Turn on your recharger by pressing the
power button
.
Tap
CONNECT
on the screen.
Then tap
SCAN CODE
. When the pop up
“requesting access” appears, tap
ALLOW
.
Aim the smart programmer camera at the
scannable code located on the blue side of the
recharger. This will connect the recharger with the
Recharger app.
Note: If the app is unable to scan the code, enter the recharger serial
number listed beneath the scannable code on the blue side of the
recharger. This will connect the recharger with the Recharger app.