EN
33
valve it is possible to reduce the tyre pressure if
it is too high.
NOTE:
The pressure gauge is not calibrated. Check
the tyre pressure with a calibrated pressure
gauge after filling.
1. Put the power switch in the "O" position.
2. Press the lock arm on the pump nipple,
fasten the nipple on the valve and release
the lock arm.
3. Plug the compressor plug into a power
point.
4. Set the switch to "I".
5. Press the trigger on the compressed air
gun and hold in for a few seconds. Release
the trigger and read off the air pressure
on the pressure gauge. Continue until the
required pressure is obtained.
6. Set the switch to "O".
7. Press in the lock arm on the pump nipple
and release from the valve.
8. Unplug the compressor plug from the
power point.
Bike tyres
Valve adapter 17 enables easy pumping up of
bike tyres.
1. Connect valve adapter 17 to the pump
nipple.
2. Press the valve adapter against the valve
and pump.
Balls
Ball needle 19 can be used for pumping up
different balls.
1. Press the lock arm on the pump nipple,
fasten the ball needle in the pump nipple
and release the lock arm.
USE
NOTE:
• Take the necessary accessories out from
the accessory compartment.
• Never block the ventilation openings.
• The appliance vibrates and should
therefore not be handled when in use.
Place the appliance upright on its four
feet on a level and stable surface.
STARTING AND STOPPING
Start the appliance by putting the power switch
in the "I" position. Switch off the appliance by
putting the power switch in the "O" position.
CONNECT THE COMPRESSED
AIR HOSE
Connect the compressed air hose with quick-
coupling: Press the compressed air connector
in the quick-coupling. The sleeve jumps
automatically forward.
DISCONNECT THE COMPRESSED
AIR HOSE
Pull back the sleeve on the compressed air
hose quick-coupling and remove the connector.
NOTE:
Hold the coupling firmly when removing the
quick-coupling to avoid personal injury as a
result of the hose kicking back.
PUMPING
Without adapter
This application enables simple and precise
filling. The pressure gauge is used to check
the tyre pressure. With the integrated blowout
