EN
15
Put the filter cartridge with the filter bag on
the motor housing and secure with the sealing
strip.
FIG. 4
Press the overhang into the filter cartridge.
FIG. 5
Fit the vacuum hose with the hose clip on the
hose sleeve on the housing.
FIG. 6
Fit the other end of the vacuum hose with the
hose clip and hose coupling.
FIG. 7
The declared vibration value and noise, which
have been measured by a standardised test
method, can be used to compare different
tools with each other and for a preliminary
assessment of exposure. The measurement
values have been
determined in accordance with EN 60335-2-
68:2012.
WARNING!
The actual vibration and noise level when
using power tools may differ from the
specified maximum value, depending on
how the tool is used and the material. It
is therefore necessary to determine which
safety precautions are required to protect
the user, based on an estimate of exposure
in actual operating conditions (taking into
account all stages of the work cycle, e.g. the
time when the tool is switched off and when
it is idling, in addition to the start-up time).
ASSEMBLY
Remove the dust collector from the packaging.
Open the sealing strip and remove the motor
housing.
FIG. 2
All the accessories are in the container.
1. Filter bag
2. Filter cartridge
3. Vacuum hose
4. Hose coupling Ø 100 mm
5. Two hose clips
Put the filter cartridge in the filter bag.
FIG. 3
