Meec tools 007339, Operating Instructions Manual

EN

22

•  Do not move or transport the product 

when the air tank is pressurised

•  Do not disconnect any air hoses when the 

air tank is pressurised.

•  Do not attempt to tamper with or modify 

the air tank or any another parts on the 
product.

•  Never point the outlet on the air hose or 

any tools connected to the hose at people 
or animals.

•  Never attempt to blow clean clothes with 

compressed air when they are being worn.

•  Never poke your fingers or other any 

objects in the casings on the product.

•  The product must only be connected to a 

230 V 50/60 Hz earthed power point that 
has a residual current device with a 
maximum tripping current of 30 mA.

•  Always connect the plug to an easily 

accessible power point so that it can quickly 
be pulled out in the event of a fault.

•  Parts of the product get hot when in use. 

Only touch the handle and the power 
switch when the product is in use.

•  Place the product on an easily accessible, 

stable and dry horizontal surface. Do not 
place the product near the edge of a table 
or bench.

•  Make sure there is adequate ventilation 

for the product. Keep the product at least 
1 m away from adjacent walls or any other 
surface.

•  Position the product so that it cannot 

move when in use.

•  The product must not stand on its own 

feet when in use.

•  Never put the product on, or near hot 

surfaces.

•  The product is not intended to be used by 

persons (children or adults) with any form 
of functional disorders, or by persons who 
do not have sufficient experience or 
knowledge on how to use it, unless they 
have received instructions concerning the 

•  Do not use accessories other than those 

specified in these instructions or recom-
mended by the manufacturer or retailer 
– risk of personal injury.

•   Repairs should be carried out by qualified 

personnel.

•  The product complies with the applicable 

safety regulations. Repairs may only be 
carried out by qualified personnel using 
identical spare parts. Serious personal 
injury can otherwise occur.

•   Risk of hearing impairment. Wear ear 

protection when using the compressor.

•  Risk of explosion. Never use the product 

where flammable material, liquid or gas 
(petrol, solvent, gas cylinders etc.) are 
stored or used.

•   Never switch off the product by pulling out 

the plug. Always use the ON/OFF power 
switch or button.

•  Always pull out the plug and relieve the 

pressure in the air tank before moving the 
product, and before service or repairs.

•  Keep the power cord away from heat, oil 

and sharp edges.

•  Do not carry or pull the product by the 

power cord or the air hoses. The product 
must only be carried with the handle.

•  Check that all the air hoses and air tools 

to be connected to the compressor are 
approved for the air pressure produced by 
the compressor, and that they are 
correctly connected.

•  The product is intended to be used in a 

well ventilated area and ambient 
temperature of 5 to 40°C.

•  Do not expose the product to water or any 

other liquid.

•  Do not use the product if the air tank is in 

any way damaged.

•  Check that all the air hoses are 

undamaged and approved for the 
pressure produced by the compressor.

•  Damaged air hoses must be replaced – 

never attempt to repair a damaged air hose.