Meec tools 008554, Operating Instructions Manual

EN

35

•  The compressor is intended to be used in 

a well ventilated area and an ambient 
temperature of +5 to +40°C. The room 
should be free from dust, acid, fumes and 
flammable or explosive gas.

•  The compressor is only intended to be 

used in dry areas. It must not be used in 
places where work is carried out with 
sprayed water.

POWER SUPPLY

•  The electric motor is ready for use on 

delivery. The electrical circuits comply with 
the requirements in the VDE and DIN 
standards. The power point to which the 
product is connected and any extension 
cords must also comply with the 
requirements in these standards.

•  The product has a power cord with an 

earthed plug. The plug can be connected 
to an earthed 230 V 50 Hz power point 
with a fuse of at least 16 A.

•  Check that the mains voltage corresponds 

to the rated voltage on the type plate on 
the product.

•  Long extension cords can result in loss of 

voltage and make starting the motor 
more difficult. Extension cords up to 25 m 
must have a minimum cross-sectional 
wire area of at least 1.5 mm².

•  The connection and the repair of electrical 

equipment must only be carried out by an 
authorised electrician.

•  An ambient temperature below +5°C can 

also make starting more difficult or 
impossible.

INTENDED USE

•  The compressor is intended to be used for 

pneumatic tools with low air consumption 
(up to 107 l/min), for example tyre pump 
nozzles, blower nozzles and paint guns. 
The compressor is not suitable for tools 
with a high consumption of air, such as 
grinders or impact wrenches.

FITTING THE SUPPORT LEG

1.  Put the hex screw (a) through the side 

foot (4). Lift up the side foot and screw, 
put the screw (a) through the hole, put on 
the flat washer (c) and spring washer (b), 
and then screw on the nut (b).

     FIG.   3

FITTING THE AIR FILTER

The supplied air filter (12) must be fitted before 
using the compressor.

     FIG.   4

     NOTE:   
The compressor must not be used without 
the air filter.

FITTING THE COMPRESSED AIR 
HOSE

An extension hose can be used if the 
compressor cannot be placed in the immediate 
vicinity of the workplace (sold separately). 
Connect the quick-coupling on the extension 
hose to one of the quick-couplings on the 
compressor (5 or 11). Now connect the 
pneumatic tool to the quick-coupling on the 
other end of the hose.

     FIG.   5

USE

PREPARATIONS

•  Check that the mains voltage corresponds 

to the rated voltage on the type plate.

•  Install the compressor as close as possible 

to the air consumption – the air hoses 
and cords should be as short as possible.

•  Make sure the intake air to the 

compressor is dry and free from dust.

•  Do not install the compressor in a damp 

area.