EN
37
PRESSURE RELIEF/EMPTYING
Relieve the pressure by switching off the
compressor and running all the air out of the
tank with a pneumatic tool, or blowing out the
air with a blower.
TRANSPORT
Use the transport handle (1) to carry the
product, or to run it on its wheels.
Take into consideration the weight of the
product when lifting (see technical data).
Safely secure the product when transporting it
in a vehicle.
TROUBLESHOOTING
See table on the next page.
POWER CORD
The insulation in the cord can easily become
damaged Frequent types of damage are:
– pinching when the cord passes
through windows or doors
– creasing if the cord is not hung up or
fastened properly
– damage caused by being run over
– damage cause by pulling the cord
(always pull the plug)
– fatigue.
WARNING!
Cords with damaged insulation are
dangerous and must not be used under any
circumstances.
• Check at regular intervals all power cords
for damage to the insulation.
• Unplug the power cord from the power
point before checking. Cord must comply
with the requirements in the VDE and DIN
standards. Only cords marked H05VV-F
must be used (type marking of cords is
mandatory).
STORAGE
Store the product and all accessories in a
clean, dry frost-free place, protected from direct
sunlight and out of the reach of children. The
best storage temperature is +5 to +30°C.
IMPORTANT:
• Switch off the switch, pull out the plug
and relieve the pressure (air tank,
connected pneumatic tools etc.).
Secure the power switch from
accidental switching.
• Store the product upright (never flat or
leaning) in a dry place out of the reach
of children and other unauthorised
persons.
Summary of Contents for 008554
Page 4: ...2 1 13 11 12...
Page 5: ...4 5 6 3 13 5 11...
