Meec tools 009208, Operating Instructions Manual

EN

16

1.  Screw the top part of the handle (6) on 

the two handle tubes (7) with two screws 
M6 x 25 (10) and two nuts.

     FIG.   3

2.  Screw the bottom tube on the handle (8) 

on the two top tubes (7) with four screws 
M6 x 30 (9), two M6 x 25 (10) and nuts 
(11).

     FIG.   4

3.  First fit one side of the handle on the 

product, press the handle together a little 
and then fit the other side.

     FIG.   5

FITTING THE GRASS CATCHER

1.  Press the frame into the tubes on the 

grass catcher.

     FIG.   6

2.   Snap the side attachments on the catcher 

over the frame.

     FIG.   7

3.   Snap the bottom attachments on the 

catcher over the frame.

     FIG.   8 

4.  Fit the grass collector on the drum. 
5.  The grass catcher must also be fastened in 

the handle with the supplied straps.

USE

INTENDED USE

•  The product is intended for cutting grass.
•  The product is only intended for 

household use, not for commercial use.

HOW TO USE

•  The lawn mower can cut grass up to 10 

cm high. 

•  Mow the lawn regularly – the grass will 

grow faster and become thicker and more 
resistant if it is kept short, unless the 
climate is very dry. 

•  Mow the lawn with a relatively high 

mowing height first, and then gradually 
reduce the height. A mowing height of 
about 2.5 cm gives the lawn a well-mown 
look. 

•  Only cut the grass when it is relatively dry. 
•  Mow in a straight line with an overlap of a 

few centimetres for best results.

Adjusting the mowing height

The lawn mower has four mowing heights, 
from 15 to 35 mm. Adjust the mowing height 
by pulling out the spring-loaded pins (A) on 
both sides and moving them to the required 
positions.

•  B is a straight blade, the fuction is to cut 

grass together with the rotating blade, 
just like the scissors.

•  C is a pull rod, it can adjust the gap 

between the straight blade and rotating 
blade by tighten the nut. If the gap is 
large, the mower can not cut grass, but if 
the gap is too small, the blade can not 
rotate smoothly.

     FIG.   9

MAINTENANCE

•  Follow the maintenance instructions for 

best functionality and useful life.

•  Clean the product with a brush or cloth 

after use.

•  Check that all screw unions are properly 

tightened at regular intervals.

•  Replace damaged or worn parts 

immediately.

•  Clean and lubricate all the screw unions 

and moving parts, such as the wheels and 
axles, at regular intervals for best