28
2022_001
4
Tighten the oil filler screw.
5
Turn the product to its operation position.
5.1.2 To change the hydraulic oil
Note!
Change the hydraulic oil after every 150 h of
operation.
1
Stop the product. Make sure that all moving parts
have completely stopped.
2
Pull out the power plug.
3
Turn the product to its short side to the ground with
the motor down.
4
Loosen the oil filler screw (C). (Figure 2)
5
Tip the product to its support legs and let the oil go
out into a container that holds a minimum of 2.4 l.
6
Turn the product to its short side to the ground with
the motor down.
7
Fill with hydraulic oil.
8
Tighten the oil filler screw.
9
Turn the product to its operation position.
10
Make sure that no oil leaks out.
5.2 To sharpen the wedge
●
Remove burrs and damage on the edge on the wedge
with a fine file.
5.3 To clean the product
●
Clean the product with a dry cloth.
6
Troubleshooting
Problem
Possible cause
Action
The motor does not start.
The overload protection is applied.
Let the motor become cool. Push the reset
button for the overload protection.
The wooden log does not split.
The wooden log is not in correct
position.
Put the wooden log in correct position.
The wooden log is too wide or too
hard to split.
Discard the wooden log.
The edge on the splitting wedge is
blunt.
Refer to “5.2 To sharpen the wedge” on page
28.
There is a oil leak.
Speak to an authorized service center.
Unauthorised adjustment of the
adjusting screw for maximum
pressure.
Speak to an authorized service center.
The piston does not move
smoothly, the product makes
abnormal noise or vibrates.
Too little hydraulic oil and too much
air in the hydraulic system.
Do a check of the hydraulic oil level. Refer to
“5.1 To do a check of the hydraulic oil” on page
27.
Oil leaks out around the piston.
There is air in the hydraulic system.
Refer to “4.1 To do before operation” on page
26.
The vent screw is not tight when the
product is moved.
Tighten the vent screw before the product is
moved.
Drain plug and dipstick is not
tightened correctly.
Tighten the drain plug and the dipstick.
The seals are worn.
Replace the seals.
The valves are worn.
Speak to an authorized service center.
Summary of Contents for 009968
Page 54: ......
