18
•
Do not use the tool if it cannot be switched on and off using the power switch. Power tools that
cannot be controlled with the power switch are dangerous and must be repaired.
•
Always disconnect the power cord from the mains power before making any adjustments, changing
accessories or putting the power tool away. These safety precautions reduce the risk of accidently
starting the power tool.
•
Keep power tools out of the reach of children and other unauthorised persons when not in use.
Power tools are dangerous if used by inexperienced people.
•
Maintain the tool in good order. Keep cutting tools sharp and clean. Properly maintained cutting
tools with sharp cutting edges are less likely to jam and are easier to control. Make sure that
moving parts are properly adjusted and do not jam and that no parts are damaged. Check for other
factors that could affect the operation of the power tool.
•
If the power tool is damaged, it must be repaired before being used again. Many accidents are
caused by poorly maintained power tools.
•
Only use accessories recommended by the manufacturer for the specific model. Accessories that
are suitable for one tool may pose a risk of injury if used with another tool.
Service
•
Service work should be carried out by qualified service personnel only. There is a risk of personal
injury if unqualified persons carry out service or maintenance on the tool.
•
Only use approved spare parts and accessories when servicing.
•
Follow the instructions in the section on maintenance in these Operating Instructions. The use of
non-approved parts or failure to follow maintenance instructions can result in electric shock or other
injury.
Specific safety instructions
Accessories must be rated, as a minimum, for the speed specified on the power tool type plate. Discs and
other accessories that rotate faster than their nominal speed can burst and cause personal injury.
TECHNICAL DATA
Rated voltage
230 V / 50 Hz
Output power
1200 W
Speed
500-3300 rpm
Polishing pad
Sound power level, LwA
Sound pressure level, LpA
Max vibration level
Ø 180 mm
106 dB(A), K=3 dB
95 dB (A), K=3 dB
8,32 m/s², K=1,5 m/s²
Wear hearing protection!
The declared vibration value, which has been measured by a standardised test method, can be used to
compare different tools with each other and for a preliminary assessment of exposure.
he measurement
values have been determined in accordance with EN 60745-2-3.
WARNING!
The actual vibration and noise level
when using power tools may differ from the specified
maximum value, depending on how the tool is used. It is therefore necessary to determine which
safety precautions are required to protect the user, based on an estimate of exposure in actual
operating conditions (taking into account all stages of the work cycle, e.g. the time when the tool is
switched off and when it is idling, in addition to the start-up time).
