Meec tools 011436, Operating Instructions Manual

EN

30

STARTING, STOPPING AND 
ADJUSTING THE SPEED

Press the power switch to start the product 
and release it to stop. The speed is variably 
adjustable from 0 to 560 rpm by pressing in 
the power switch.

LIGHT

The light goes on when pressing the power 
switch and goes off when it is released.  
Clean the light aperture (1) when necessary 
with a soft, clean cloth to avoid scratching  
and obscuring it.

     FIG.   2

ROTATION SELECTOR

The direction of rotation for the flexible auger 
can be changed with the rotation selector. 
It can only be changed when the auger has 
stopped. Press "A" to rotate in normal  
working mode and "B” to rotate backwards.  
The selector must be fully pressed in the 
required direction of rotation in order to press 
the power switch. When the product is not in 
use the selector should be left in the mid point 
to prevent unintentional starting.

     FIG.   3

     NOTE:   
Only use backwards rotation to pull out the 
auger if it has got stuck. 

AUTOMATIC FEEDING

1.  Press the rotation selector button "A". 

Press the power switch a little and move 
the feed lever forwards to "F". The auger 
now feeds out (forwards).

     FIG.   4

USE

PREPARATIONS

•  Check that the watertight plug on the 

drum is inserted and tightened and that 
the hex key is removed.

•  Lubricate the flexible auger in accordance 

with the instructions.

•  Check the auger for wear and damage. 

Replace the auger if it is worn flat, 
deformed or is damaged by corrosion.

•  Familiarise yourself with the product and 

how to use and control it before starting 
to use it.

•  Switch off the product with the power 

switch and remove the battery before 
adjusting or checking the product.

FITTING AND REMOVING THE 
BATTERY

Battery and charger sold separately in Jula’s 
department stores and at www.jula.com.
1.  Check that the power switch is in the OFF 

position before putting in or removing the 
battery.

2.  To fit the battery, align the red markings 

on the battery to the slot in the battery 
holder and press the battery in place.  
The battery should be pressed into the 
battery holder slot all the way until it clicks 
in place, otherwise it can drop out when 
in use. Never attempt to force the battery 
in place. If the battery does not slip 
easily in place it is probably not correctly 
aligned.

3.   To remove the battery from the product, 

press in button on the back of the battery 
and pull back the battery.