EN
32
REPLACING THE AUGER
The product has a quick-coupling to facilitate
replacing the auger.
1. Put the feed lever in the "0" position.
2. Take out the auger to expose the auger
coupling.
3. Undo the lock screws, M4, (1) with a hex
key (2) and remove the auger (3).
FIG. 8
4. Push the new auger (1) in the auger
coupling, align the screw holes and
tighten the lock screws (2).
5. Press the auger by hand back into the
drum. Do not run in the auger with the
motor – when the full length of the auger
is exposed it can move uncontrollably
and cause personal injury and material
damage.
AFTER EACH USE
1. Turn the drum by hand after use until the
watertight plug is exposed outside the
casing.
2. Unscrew the plug with a hex key and
remove it.
3. Hold the product with the hole down until
the liquid in the drum has run out and
then replace the plug.
FIG. 9
NOTE:
Remove the hex key when the plug is
replaced – if the key is left in place it can be
thrown out and cause personal injury the
next time the product is started.
4. Carefully clean the auger and the drum.
Apply a little grease on the surface of the
auger to prevent it rusting if the product is
not going to be used for some time.
Summary of Contents for 011436
Page 4: ...2 1 1 2 3 4 5 6 1 ...
Page 5: ...4 5 3 B A ...
Page 6: ...6 7 1 ...
Page 7: ...8 9 1 2 3 ...
